Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Interior Section: Door Lock
Model Year: 2008 Model: Sequoia Doc ID: RM000002ZPV004X
Title: DOOR LOCK: FRONT DOOR LOCK: REMOVAL (2008 Sequoia)

REMOVAL

HINT:

  • Use the same procedure for the LH side and RH side.
  • The procedure listed below is the LH side.

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers) DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

4. REMOVE FRONT ARMREST BASE UPPER PANEL DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

6. REMOVE FRONT DOOR TRIM NO. 1 BRACKET DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

7. REMOVE FRONT DOOR SERVICE HOLE COVER DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

8. REMOVE FRONT DOOR GLASS RUN DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

10. REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+

11. REMOVE FRONT DOOR LOCK

(a) Using a "TORX" socket wrench T30, remove the 3 screws.

(b) Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and cables as a unit.

(c) Remove the door lock wire harness seal from the front door lock.

(d) Remove the front door lock remote control cable.

(e) Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.

(f) Remove the front door inside locking cable.